Reggie Marlow

And keep the client-side acknowledge as a fallback for when your backend was unreachable at purchase time. Doing it in both places is normal here, not paranoid - the operation is idempotent and the downside of missing it is total.

Also move it off Actions. Scheduled workflows are for maintenance chores where nobody notices a missed night. Anything customer-facing wants a scheduler that is part of your app's platform, where a missed run is visible in the same place as everything else you look at.

Point them at the staging database. Branches are a lot of setup for the same outcome and you get realistic data for free.

Playwright does have its own component testing but it has been experimental for a long time and I would not build a small team's daily workflow on it right now.

Doing stabs first is the biggest single time saver on the list. I ignored that advice once and spent forty minutes with tweezers and a lot of swearing.

I own four neck pillows and regret three. The one I kept is a plain memory foam horseshoe that I wear backwards, with the thick part under my chin, which stops the forward nod and cost about a fifth of the fancy ones. I only discovered this by accident on a delayed flight and it has been my whole system since.

The attached screenshot is the message. Whatever they photographed is where they got stuck - that is not a coincidence, it is them showing you the state they were in.

If it is the paywall, they were trapped on the paywall, and a paywall a reviewer cannot dismiss is its own rejection waiting to happen on a completely different guideline. Fix the dismiss and this problem probably disappears along with the next one you have not had yet.

Both stores with Expo is genuinely not much more work than one - the delta is console setup, a second set of store assets, and a real Android device to test on. If you are already in that ecosystem the marginal cost is a weekend rather than a rewrite.

The ring is case resonance, and the fact that it is worse on the far side from the daughterboard supports that, because that is the biggest uninterrupted air gap. A strip of self adhesive shelf liner or a piece of neoprene sitting in the bottom of the case does more for that than anything mounted on the PCB. Cheap, invisible, easily removed.

Photograph every connector before you unplug anything. They are all keyed differently until the one that is not.

Micronised just means finer particles, so it dissolves better. It isn't a different compound and it isn't stronger.

Two units here and I would say one is the worst number. One is all of the admin, all of the compliance, all of the learning curve, and none of the smoothing. Two was noticeably easier per unit than one, which sounds absurd but the fixed costs of knowing what you are doing are already paid. That said, scaling up to fix a problem is how people end up much more exposed than they intended.

Swap in a different spacebar keycap before you tear it down a third time. Some spacebar stems, particularly long thin ABS ones, are loose on the stem and the rattle you hear is the cap moving on the switch, not the stabiliser at all. Two minute test.

Also do not drown the housing. Excess grease damps it initially, then squeezes out onto the PCB and you are back where you started with a mess to clean.

The boring answer nobody wants: you are already running Postgres. Do B until it hurts. It will not hurt at 5k.

A working week and a half per move is the number I was missing. Eleven of those a year is obviously insane when you write it down.

Agreed, and get a cheap hardness test rather than guessing from your water company's average. Mine varies enough across the year that the annual figure was useless.

HOLD_ON_OTHER_KEY_PRESS plus a per key term of 220 on that one key has it at zero misfires over an afternoon. Thank you.

That also explains why the phone feels sluggish if I skip it and start using it immediately. Nothing is broken, it is just compiling on demand while I use it.